Fujitsu SPARC ENTERPRISE M3000 Manual de usuario descargar pdf (Pagina 71)

Chapter 3 Troubleshooting 3-19

3.5.6 Using the fmstat Command

The fmstat command reports statistical information and a set of modules that are

associated with the module called Solaris Fault Manager. By using the fmstat

command, statistical information about the diagnostic engine and diagnostic agent

that are currently involved in fault management can be displayed.

The following output example shows that the fmd-self-diagnosis DE module

(displayed also on the console output) has received accepted events.

3.6 General Solaris Troubleshooting

Commands

Superuser commands of this type are useful to determine whether there is a problem

with the server, network, or another server connected via the network.

This section explains the following commands:

■ “Using the iostat Command” on page 3-20

■ “Using the prtdiag Command” on page 3-21

■ “Using the prtconf Command” on page 3-23

■ “Using the netstat Command” on page 3-26

■ “Using the ping Command” on page 3-27

■ “Using the ps Command” on page 3-28

■ “Using the prstat Command” on page 3-29

# fmstat

module ev_recv ev_acpt wait svc_t %w %b open solve memsz bufsz

cpumem-diagnosis 0 0 0.0 0.0 0 0 0 0 3.0K 0

cpumem-retire 0 0 0.0 0.0 0 0 0 0 0 0

disk-transport 0 0 0.0 1793.8 0 0 0 0 40b 0

eft 0 0 0.0 0.0 0 0 0 0 1.2M 0

event-transport 0 0 0.0 0.0 0 0 0 0 210b 0

fabric-xlate 0 0 0.0 0.0 0 0 0 0 0 0

fmd-self-diagnosis 0 0 0.0 0.0 0 0 0 0 0 0

io-retire 0 0 0.0 0.0 0 0 0 0 0 0

snmp-trapgen 0 0 0.0 0.0 0 0 0 0 32b 0

sysevent-transport 0 0 0.0 2395.3 0 0 0 0 0 0

syslog-msgs 0 0 0.0 0.0 0 0 0 0 0 0

zfs-diagnosis 0 0 0.0 0.0 0 0 0 0 0 0

zfs-retire 0 0 0.0 0.0 0 0 0 0 0 0

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 211 212

Sin comentarios

Fujitsu SPARC ENTERPRISE M3000 Manual de usuario Pagina 71